Hi Markus,

After confirmation, the Sinkmark information is indeed missing in the Pin Movement of the 2024R2 version. We will ask the R&D department to verify and fix this issue as soon as possible. We will get back to you with further updates. Thank you.

Hi Erdem,

Normally, we will observe the instant when the part gets frozen.

If most of the cavity is frozen before the end of packing (EOP), then please observe and check the result until EOP.

If most of the cavity is frozen after EOP, then please check the result of extended packing.

Hi Lisa,

Currently, Moldex3D supports geometric nonlinearity analysis, which considers the effect of deformation that may cause changes in structural stiffness. Therefore, the fitness lies in whether the stiffness changes due to geometric deformation, which usually occurs in cases of large deformations or geometries prone to buckling.

Marcus