Home

RE: Pre-cured material injection molding

Is it possible to make a simulation with injecting pre-cured material?  Reach 10% conversion for an epoxy with curing it, after that start injection molding with it.

Ann Asked on 6 11 月, 2024 in Moldex3D.
Add Comment
Cancel
1 Answers

You can adjust the initial conversion percentage as the picture below in the process wizard.

RE: Pre-cured material injection molding

Cancel
Answered on 6 11 月, 2024.
Add Comment
Cancel

Your Answer

By posting your answer, you agree to the privacy policy and terms of service.