RE: I want to make sure, there won’t be voids in the part, shall I use the EOP volumetric shrinkage, or the warpage volumetric shrinkage result?
I want to make sure, there won’t be voids in the part, shall I use the EOP volumetric shrinkage, or the warpage volumetric shrinkage result?
Only standard warp will output warpage volumetric result, and the one in the warp result is volumetric shrinkage at room temperature. Enhanced warp doesn’t have this. Normally we will observe the instant when the part gets frozen.
If most of the cavity are frozen before EOP, then please observe and check the result until EOP.
If most of them are frozen after EOP, then please check the result of Extend packing.
